Potentiometer TPS Throttle Position Ssensor V8 Landrover LRSPAREPARTS

POTENTIOMETER - Manufacturer: - Type : ELECTRICS AND WIPERS - Key Word Search : RD ***NEW STOCK NOT LUCAS BRAND - BUT BESPOKE MADE - (LUCAS NO LONGER HAVE IN THEIR RANGE)*** HELPFUL DIAGNOSTIC NOTES Throttle Position Sensor (TPS) Failure: TPS sensors often fail due to high heat under the BONNET/HOOD. Signs of Failure: + Check Engine Light with codes ranging from P0120 through P0125 + Engine hesitation when accelerating + Rough Idle. Find the Throttle pot on side of plenum. There are three (3) wires coming from this unit to a multi plug. Do not disconnect. Wire colors are Red, Green, Yellow. Red from volt meter to red wire of pot. Black wire from volt meter to Green of pot. Volts should read .33 to .35 volts if not, loosen the two (2) screws that hold it in position and turn it to get the correct voltage. If you cannot get the correct voltage setting, undo and remove the throttle pot, make the fixing holes elongated and you will be able to get the right voltage. WIRING NOTE: Go by the loom wiring colour rather than the potentiometer wiring colours. The centre termal is the switch adjustment RED. The BLACK wire should go the earth. The BLUE is the other side of the power. So the YELLOW to BLUE. the BLACK to GREEN . the RED to RED. If you have both potentiometer facing the same direction you should be able to copy the wiring. For example both pointing downwards. ERR2263 ETC8495 70408a